Rear Individual Map Light Removal, Installation, and Test

NOTE: enu_12713377_2.0 Where icon is shown, click for further information.


1

4108_3.0_enu_14881235_4.0

enu_12713377_2.0
Detailed information, notes, and precautions
enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)
*1
Rear Individual Map Light: LED
Ambient Light: LED

1. Lens - Remove

Carefully pry off the lenses.

2. Rear Individual Map Light - Remove


3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. Rear Individual Map Light - Test
1.
Check the rear individual map light (A) according to the table.
NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
2.
If the result is not as specified, replace the rear individual map light.